Sussan Ley Approved Iron-On T-Shirt Transfer

Sussan Ley has strong opinions about what constitutes an appropriate t-shirt. Avoid being hassled from the Opposition Leader with this pre-approved iron-on transfer.

22cm wide x 17cm high.

Can be applied to most t-shirts (cotton, cotton blends, polyester).

T-shirt and man not included.

___________________________________

(Application Instructions)

- Set your iron to the highest temperature appropriate for your garment. Typically, the “Cotton/Linen” setting . (Do not use steam – empty any water, and use the iron dry)

- Place your t-shirt on a hard, flat surface (a wooden table with a towel might be even better than an ironing board). Pre-iron the area to warm it up and remove moisture.

- Position the transfer and cover it with a piece of baking parchment or kraft paper

- Press down firmly with the iron, using your body weight if needed, for about 20 seconds in each spot. Move the iron in sections to make sure to overlap areas so the whole design gets heat. Do NOT slide the iron around. Just press, lift, and press on the next section to avoid shifting the transfer.

- Allow it to cool completely. Then peel the film off. If any part isn’t sticking, put the film back and press that area again with more pressure and maybe a bit more heat. These transfers can handle multiple presses, so you can retry until it’s on.

- After peeling, definitely do a final press with parchment paper over the design for another ~15 seconds. This helps set the design fully and improve durability, especially since irons give uneven heat.

- Washing: It's best to wash these garments inside-out on cold and hang dry.

Share